M
Mister Ed
Forum Guest
Register Today
Hi guys -
I just bought a SB shaper and need help wiring the motor. The motor is an older (I think) GE 110v. There are no numbers or info on the motor, not even wiring diagram. The previous owner did have it wired for 110. But had unhooked the motor wiring when he crated the unit up.
So, as expected I have a white, black & ground wire coming in. Under the motor plate I have 5 terminals, the jumpers were there from PO ... so I suspect should remain. The terminal numbers are numbered from top: 1,2, there is a number3 stamped next to the 2 but no terminal and then 4, 5 & 6. So, where do I connect my wires to? I would think L1 to T1/T2, L2 to T4/T5. Anything to T6? Ground wire to the case?
I just bought a SB shaper and need help wiring the motor. The motor is an older (I think) GE 110v. There are no numbers or info on the motor, not even wiring diagram. The previous owner did have it wired for 110. But had unhooked the motor wiring when he crated the unit up.
So, as expected I have a white, black & ground wire coming in. Under the motor plate I have 5 terminals, the jumpers were there from PO ... so I suspect should remain. The terminal numbers are numbered from top: 1,2, there is a number3 stamped next to the 2 but no terminal and then 4, 5 & 6. So, where do I connect my wires to? I would think L1 to T1/T2, L2 to T4/T5. Anything to T6? Ground wire to the case?