Excello 602 help needed

[buffdan]

I am picking up a 602 this week, and the mill is missing the quill hand lever assembly, and the quill power fee clutch knob
Would anybody be able to take some close up pictures for me, and some idea of dimensions?
I will need to machine these.. I am looking for originals, but no luck so far. Tried the gentleman in Canada.. No luck there.
Thank you very much !
Dan

 

[NCjeeper]

When I get a chance I will get you some info.

 

[buffdan]

Thank you!!

 

[NCjeeper]

I measured with everything together so I maybe off a few thousands here and there but shouldn't make that much of a difference.

 

[buffdan]

Thanks!.... The feed knob, I assume ID to be same as quill handle? Also, the knob has threaded hole? Is it stepped Hole?
I can estimate pin hole location when I get the machine.
Thank you again!

 

[NCjeeper]

Yes the knob is threaded internally. Left hand thread I think. The retaining hole is stepped. I can grab a pic tomorrow.

 

[buffdan]

Thank you.. Sorry to be a pain.. I do appreciate your help.

 

[NCjeeper]

Finally got down to the shop today.

 

[buffdan]

Ahhhh, Thank you very much. I didn't expect to see those holes drilled around the perimeter.
I appreciate it greatly!!
Dan

 

[buffdan]

Thanks Tom!
Just have to install indexing pin for the handle collar. .. Though I'm Not sure why the knob has the 8 indexing holes.
They don't seem to be necessary.
Fun project

Dan