- Joined
- Jun 6, 2015
- Messages
- 283
Picked this up earlier this year, striped it, painted it, and rebuilt it. The problem was with the drive arbor. All I had was a picture to go off of, plus the female spline. The spline is a straight spline, 1" OD. I used an involute cutter to rough in the spline, then fit it by hand with a carbide burr and file. All told I spent about 10 hours making it. I used 4140QT.
I only ran it for a few minutes, but it seemed fine, no vibrations or any heat.
Jason
I only ran it for a few minutes, but it seemed fine, no vibrations or any heat.
Jason