A
Alex
Forum Guest
Register Today
Absolutey nowhere in the manual did it say that you had to initiate the commands ON the keypad.
I only found this out from the FM50 Manual.
So I finally got my lathe working. ie....VFD-Motor-start,stop.reverse,stop.
Got the acceleration & decel time down to 2 sec's, I don't want to push my luck, so ill leave it there.
There is one other thing that is bugging me.
What is the ( SP1 ) For? ie What do i attach it to?
I have an inverter similar to the FM50.
Alex.
I only found this out from the FM50 Manual.
So I finally got my lathe working. ie....VFD-Motor-start,stop.reverse,stop.
Got the acceleration & decel time down to 2 sec's, I don't want to push my luck, so ill leave it there.
There is one other thing that is bugging me.
What is the ( SP1 ) For? ie What do i attach it to?
I have an inverter similar to the FM50.
Alex.