- Joined
- Jan 23, 2013
- Messages
- 107
I am having some problems when turning on the lathe. I get this irregular bumpy finish not matter what the speed feed or tool used.
It doesnt matter how close I am to the headstock either.
hss produces a different pattern vs carbide but the pattern is still there.
The picture show part of the barrel where I polished out the marks.
Could the motor cause these marks? My lathe is a grizzly 12x36 belt drive
It doesnt matter how close I am to the headstock either.
hss produces a different pattern vs carbide but the pattern is still there.
The picture show part of the barrel where I polished out the marks.
Could the motor cause these marks? My lathe is a grizzly 12x36 belt drive