- Joined
- Feb 17, 2013
- Messages
- 4,407
That may well be an RF-25 clone ... the size of the table is a bit smaller than my Grizzly RF-30 clone. The column diameter would probably be the deciding factor. RF-25 mills have a ø92mm (~3 ⅝") diameter column, RF-30 ~4 ½". Yours is made in Taiwan, which is a plus. The surface rust should clean up nicely. Here's a link to Rong-Fu's spec sheet for the RF-25:
www.rongfu.com
Once you have your mill cleaned up, be sure to do a search here for posts that contain "rf-30" Lots of good info on ways to trick out your mill!
Bench Type Milling Drilling Machine RF-25 - RongFu
Bench Type Milling Drilling Machine RF-25 Small workshop workhorse milling drilling machine capable of handling a range of small workpiece requirements.
www.rongfu.com
Once you have your mill cleaned up, be sure to do a search here for posts that contain "rf-30" Lots of good info on ways to trick out your mill!