- Joined
- Oct 21, 2017
- Messages
- 504
Some time ago I bought these because they were remarkably reasonably priced and I was sure I'd find a holder for them at some point.
So that didn't happen and whilst tidying today I was moving them to my drawer of miscellaneous thread cutting equipment I had an idea.
The nut & bolt stash yielded these -
I bored the nut halfway to clear the un-threaded section of the bolt then machined three sides to fit one of my QCTP holders
Assembled it looks like this -
And it actually works!
So that didn't happen and whilst tidying today I was moving them to my drawer of miscellaneous thread cutting equipment I had an idea.
The nut & bolt stash yielded these -
I bored the nut halfway to clear the un-threaded section of the bolt then machined three sides to fit one of my QCTP holders
Assembled it looks like this -
And it actually works!