I am in the final research stages for the purchase of a second mill. I got an estimate to run another 220 line into the garage for the mill since I was most interested in a 45. However, since my present box is full the line would need to come in from the outside and require pulling almost 100'. The cost of running the new line is outside my present allowance for this addition. Therefore I am back down to the Grizzly G0704 or similar mill.
My questions for those who own one are:
I have in the past made the beds for my two lathes and other mill. But this one comes with the stand. So I need to consider it.
Thanks
My questions for those who own one are:
- Are you using the accompanying stand?
- If yes, do you find it adequate?
- Would you prefer an alternate stand of you own fabrication?
- What do you not like about the Grizzly stand?
I have in the past made the beds for my two lathes and other mill. But this one comes with the stand. So I need to consider it.
Thanks