I can not seem to get a straight, squared cut/part off on lathe. My blade is 1/16" x 1/2"x 4" M2 HSS. Every time I part something the face is tapered somewhat. Ends up like a shallow cone toward the center. Not pronounced enough to post a useful photo.
Is my parting tool too thin to cut off 1" diameter aluminum rod? I square it up with the face of the part so I'm pretty sure that is not the problem.
Appreciate any tips.
Regis
Is my parting tool too thin to cut off 1" diameter aluminum rod? I square it up with the face of the part so I'm pretty sure that is not the problem.
Appreciate any tips.
Regis