- Joined
- Nov 8, 2012
- Messages
- 783
With a lot of input from this forum, I decided to purchase a Glacern GSV-440 vise.
It showed up today and is now on my mill.
After mounting and squaring up the vise, ran dial indicator across the fixed jaw and it stayed on Zero all the way across. Cut a few chips for a mounting bracket and, so far like it way better than the old vise I had.
It showed up today and is now on my mill.
After mounting and squaring up the vise, ran dial indicator across the fixed jaw and it stayed on Zero all the way across. Cut a few chips for a mounting bracket and, so far like it way better than the old vise I had.