- Joined
- Feb 7, 2013
- Messages
- 792
Hi I am new to the forum and would like to show you the power feed I made for my new Grizzly mill. It uses a gearhead motor from a surplus ICBM missle originally used to work the flap surfaces. I also made an in and out clutch for it and it uses a dart speed control. Works great and that little motor is really slow and steady where it counts. I had a Atlas mill but after I got this one I liked it so much I sold the Atlas. Ray![100_0355.JPG 100_0355.JPG](https://www.hobby-machinist.com/data/attachments/13/13533-8a034e44fec310b12c13efa2cb76e70f.jpg)
![100_0355.JPG 100_0355.JPG](https://www.hobby-machinist.com/data/attachments/13/13533-8a034e44fec310b12c13efa2cb76e70f.jpg)
![100_0355.JPG 100_0355.JPG](https://www.hobby-machinist.com/data/attachments/13/13533-8a034e44fec310b12c13efa2cb76e70f.jpg)
![100_0355.JPG 100_0355.JPG](https://www.hobby-machinist.com/data/attachments/13/13533-8a034e44fec310b12c13efa2cb76e70f.jpg)
Last edited: