I broke both the nylon transmission gears in my mini-mill.
Problem is I can't figure out how to remove the spindle assembly so I can replace the gears. I have removed everything down to the two large bearings and am now at a standstill. I have the schematic but still can't figure it out. The only thing I can think is the whole assembly is a press fit. However I hesitate to start pounding on the spindle without knowing for sure.
Help.
Problem is I can't figure out how to remove the spindle assembly so I can replace the gears. I have removed everything down to the two large bearings and am now at a standstill. I have the schematic but still can't figure it out. The only thing I can think is the whole assembly is a press fit. However I hesitate to start pounding on the spindle without knowing for sure.
Help.