- Joined
- Feb 27, 2012
- Messages
- 377
+another on the Everlast 250ex. Going on 3 years now without a hiccup. Hardest I pushed it was an angled joint between 3" square solid alum and 3" square 1/4" wall alum tube. Full 1/4" deep bevel, a little preheating then about 30+ minutes of multi-pass welding to fill the joints fully. It didn't even whimper.
Sent from my iPhone using Tapatalk![98bb47fadf3789ad70c0770addd3584a.jpg 98bb47fadf3789ad70c0770addd3584a.jpg](https://www.hobby-machinist.com/data/attachments/133/133601-5951317e2e7e85685724edcd53973a98.jpg)
The job was the posts for theses sun shades.
![98bb47fadf3789ad70c0770addd3584a.jpg 98bb47fadf3789ad70c0770addd3584a.jpg](https://www.hobby-machinist.com/data/attachments/132/132173-5951317e2e7e85685724edcd53973a98.jpg)
![98bb47fadf3789ad70c0770addd3584a.jpg 98bb47fadf3789ad70c0770addd3584a.jpg](https://www.hobby-machinist.com/data/attachments/132/132180-5951317e2e7e85685724edcd53973a98.jpg)
![98bb47fadf3789ad70c0770addd3584a.jpg 98bb47fadf3789ad70c0770addd3584a.jpg](https://www.hobby-machinist.com/data/attachments/132/132203-5951317e2e7e85685724edcd53973a98.jpg)
Sent from my iPhone using Tapatalk
![98bb47fadf3789ad70c0770addd3584a.jpg 98bb47fadf3789ad70c0770addd3584a.jpg](https://www.hobby-machinist.com/data/attachments/133/133601-5951317e2e7e85685724edcd53973a98.jpg)
The job was the posts for theses sun shades.
![98bb47fadf3789ad70c0770addd3584a.jpg 98bb47fadf3789ad70c0770addd3584a.jpg](https://www.hobby-machinist.com/data/attachments/132/132173-5951317e2e7e85685724edcd53973a98.jpg)
![98bb47fadf3789ad70c0770addd3584a.jpg 98bb47fadf3789ad70c0770addd3584a.jpg](https://www.hobby-machinist.com/data/attachments/132/132180-5951317e2e7e85685724edcd53973a98.jpg)
![98bb47fadf3789ad70c0770addd3584a.jpg 98bb47fadf3789ad70c0770addd3584a.jpg](https://www.hobby-machinist.com/data/attachments/132/132203-5951317e2e7e85685724edcd53973a98.jpg)