I am looking to replace the motor on the HF 8x12 Lathe as it seems underpowered on steel turning at 3 inch diameter, and I am only taking off .040 at a time, and it will stall.
Where can I find higher performing motor ? What is the CR CS about ? The present specs are:
Single Phase Capacitor Start CE
And Capacitor Running
Type JWL_7124 IP 44
350 watt .75 HP 120 volt 8 amp (yeah - it is not continuous duty 8 amp for sure)
60 Hz 1740 RPM
Ins B 5.4 Kg
CR 20 4/F 450 V
CS 40 4/F 250 V
(And I may as well take this motor and put it on the Drill Press to upgrade it )
Where can I find higher performing motor ? What is the CR CS about ? The present specs are:
Single Phase Capacitor Start CE
And Capacitor Running
Type JWL_7124 IP 44
350 watt .75 HP 120 volt 8 amp (yeah - it is not continuous duty 8 amp for sure)
60 Hz 1740 RPM
Ins B 5.4 Kg
CR 20 4/F 450 V
CS 40 4/F 250 V
(And I may as well take this motor and put it on the Drill Press to upgrade it )