I have an enclosed Emerison 1hp motor single phase, which is reversable. It has two capacitors on the top but no diagram. Attached is a diagram of the terminal plate I drew.
1. POWER ( White power comes in on terminal 1 and black power comes in on terminal 4)
2. Terminal 2 is empty
3. Red is on terminal 7
4. Black and white are on terminal 3
(Exchange the red and black, to make the motor reverse)
5. Terminal 5 is empty and near the red wire mentioned below
6. There is a red motor wire which does not attach when on 115 volt
How do I convert it to run on 230 volts? There is no label on the motor
1. POWER ( White power comes in on terminal 1 and black power comes in on terminal 4)
2. Terminal 2 is empty
3. Red is on terminal 7
4. Black and white are on terminal 3
(Exchange the red and black, to make the motor reverse)
5. Terminal 5 is empty and near the red wire mentioned below
6. There is a red motor wire which does not attach when on 115 volt
How do I convert it to run on 230 volts? There is no label on the motor