New to tapping... I bought this T-handle tap set online to use to tap an M3 hole in plastic and I can't for the life of me figure out how to get the tap to seat properly in the chuck.
The larger sizes fit ok and I can tighten the chuck down on them but the M3 is just too small and wiggles around.
Am I missing something or did I get a mismatched set somehow?
![IMG_9023.JPG IMG_9023.JPG](https://www.hobby-machinist.com/data/attachments/353/353567-6c076604334e439659adbdbf828b0be2.jpg)
![IMG_9024.JPG IMG_9024.JPG](https://www.hobby-machinist.com/data/attachments/353/353568-c4afebded44c7e51b231ecf58deabf9e.jpg)
The larger sizes fit ok and I can tighten the chuck down on them but the M3 is just too small and wiggles around.
Am I missing something or did I get a mismatched set somehow?
![IMG_9023.JPG IMG_9023.JPG](https://www.hobby-machinist.com/data/attachments/353/353567-6c076604334e439659adbdbf828b0be2.jpg)
![IMG_9024.JPG IMG_9024.JPG](https://www.hobby-machinist.com/data/attachments/353/353568-c4afebded44c7e51b231ecf58deabf9e.jpg)