As mmcmdl suggests I would use dowel pins. Those from McMaster are ground to within +.0001" to +.0003". Over the years I've purchased several sizes and lengths just for this purpose. I most often use either a 1/2" or 1" pin 4" long. I doubt that there are many members using lathes that are more accurate.
Attached is a copy of an inspection sheet that came with every Sheldon lathe. Note the acceptable runout is generally .0001" to .0003". That's new from the factory.
Drill rod (available at McMaster) is generally pretty accurate as it is ground to size.
Looks like you have an adjust tru back plate . Dial it in at the collet . That's the best it can get .
Or a drill blank, 3/8" is plenty.Dowel pins are not always round, especially when tenths are concerned. I recommend a gage pin instead 23055A99. It's 2x the price but probably the same shipping.
You loosen the 3 bolts holding the chuck to the back plate, then lightly snug them back up. The 4 screws around the perimeter are used to dial the part in. It's just like dialing in a 4 jaw chuck except you don't crank down on the adjustment screws. It's a finesse thing, snug is good! Once you're happy with the runout, tighten the 3 mounting bolts a little more. They don't need to be over tightened either.I have now taken the third measurement, as close to the chuck as possible without crashing the indicator using three different broken endmills in three different collets. One of the mills has some engravings on it but the last one (0.25") has no visible markings.
The setup is:
PM ER40 chuck ("Very High Quality collet chuck")
PM ER40 metric collet set. ("Precision Ground Clamping Surfaces, max runout .0005″")
RegoFix HiQ ER40 Bearing collet nut. Torqued by hand, factory spec is ~130 lb-ft
I understand tolerance may stack up, but 1.8 thou is a lot, isn't it?
Can you please point to a video or a write-up of this method? I have no idea what you are talking about. I do appreciate your willingness to help a beginner.
You are probably not on center horizontally. The perceived runout will be less on the smaller diameter. I would set the indicator up to read the top side and use the cross slide to find the high spot and then make the runout measurement.I found an old, broken (crashed) Tormach threadmill with a 0.5" shaft, so I repeated the experiment, and it is, sadly, more believable. Interestingly the runout is lower on the thinner neck even though it's farther from the chuck.
sorry, but I don't like the pins you are using. 2 things I have issues with.I have now taken the third measurement, as close to the chuck as possible without crashing the indicator using three different broken endmills in three different collets. One of the mills has some engravings on it but the last one (0.25") has no visible markings.
The setup is:
PM ER40 chuck ("Very High Quality collet chuck")
PM ER40 metric collet set. ("Precision Ground Clamping Surfaces, max runout .0005″")
RegoFix HiQ ER40 Bearing collet nut. Torqued by hand, factory spec is ~130 lb-ft
I understand tolerance may stack up, but 1.8 thou is a lot, isn't it?
I am now looking at the PM documentation of the collet chuck to see if I can adjust it. Can you please point to a video or a write-up of this method? I have no idea what you are talking about. I do appreciate your willingness to help a beginner.