- Joined
- Mar 26, 2018
- Messages
- 8,411
I pulled the mag chuck off my surface grinder.
The t-slots have grown some surface rust since the last time I performed this maintenance.
I am an Evaporust fan, I was hoping I could scrub clean the tape mating surface to hold some To clean up the rust.
It leaked out.
My goal is to clean the t slots of all rust and debris/grease then apply a product to prevent rust under the mag chuck.
This is a flood coolant equipped Brown and Sharpe SG.
Thank you for your ideas.
Jeff
The t-slots have grown some surface rust since the last time I performed this maintenance.
I am an Evaporust fan, I was hoping I could scrub clean the tape mating surface to hold some To clean up the rust.
It leaked out.
My goal is to clean the t slots of all rust and debris/grease then apply a product to prevent rust under the mag chuck.
This is a flood coolant equipped Brown and Sharpe SG.
Thank you for your ideas.
Jeff