Aside from the Chinese anvils sold by HF, etc. which may be cast iron, most modern anvils are made from cast steel. (Older anvils were made from wrought iron with a forge welded steel face,) I don't know that there is much difference metalurgically between brands. I would pick a pattern that suits your needs. The farrier's pattern as sold by NC Tool is designed for making horseshoes and is characterized by the swelled horn. It sometimes has a side protrusion for drawing retaining clips on horseshoes that may be more of an inconvenience on a general purpose anvil.I would imagine the shipping cost for an anvil would be high!
Centaur forge sells,
Atlas knife and tool
Cliff Carrol
Emerson
JHM
Kanca
Mathewson Metals
NC Tool
Scott
TFS
If a guy wanted a general use anvil say 150#. What would be a good brand to buy?
I see used anvils from time to time, the prices are out of sight.
Carry on. It will fit in the overhead if it's 200 lbs or less.Hey honey, I found one I like. Shipping back to the states will take six weeks for only $1,200. (I’m guessing here)
Still married?
You can be sure of it!!She was offered over $450 6 years ago. Bet it is worth more today.
Too close!!Told once before but worth a repeat. Bill Pieh was the founder and owner of Centaur Forge. He was an avid pilot and owned a small twin engine plane which he used to fly to various blacksmithing and farrier conventions around the country.
On one occasion, he loaded five anvils into the back of the plane. En route, he hit some turbulence and the anvils shifted towards the front of the plane, upsetting the trim of the plane. He managed to recover with some fancy maneuvering, averting a nose plant into terra firma and landed at the nearest field. He never flew with cargo the wasn't securely fastened in place again.