I needed some 0.625 x .050 Square Brass Tubing yet, while this is standard size, it appears to be poorly stocked.
So, I'm considering either milling, or filing, down the insides of 0.625 x 0.062 stock. I'll be working on only a 1/2" length of tube so, it's only .012 to be removed and that only on two opposing sides. Milling would still require a bit of filing to finish the edges.
Any comments or better ideas?
So, I'm considering either milling, or filing, down the insides of 0.625 x 0.062 stock. I'll be working on only a 1/2" length of tube so, it's only .012 to be removed and that only on two opposing sides. Milling would still require a bit of filing to finish the edges.
Any comments or better ideas?