Jacobs MT4 x #5 JT Chuck Adapter

[Buffalo21]

Free to the first responder, I have a Jacobs MT #4 (shank) x #5 JT (arbor end) chuck adapter. It is free, I’ll even split the postage.

 

[Alexander McGilton]

Are you sure that is not a JT 5 on the left end?

Let me see if there is something I can part with, since that would actual be usefull to me at work. We could arrange to swap something of equal low value.

 

[Buffalo21]

Yes, my fat fingers it’s a MT#4 x #5 JT..... sorry did not reread my post

 

[Alexander McGilton]

I have this sliding bevel square. A Millet, made in England. I was told that it would be set by protractor then would set a bevel on a wood router, molding plainer or a combination chop saw. I image it was intended for setting a sharper or meta planer. You have a ground tool 2-6inch off the vise the would be vary helpful to set the angle up there before first cut.
Would a trade interest you?

 

[Buffalo21]

Send me an address, I’ll send it to you, I’m not looking for any kind of payment, I was hoping someone could use it

 

[Alexander McGilton]

Check your messages on the blue banner. click the envelope next to the bell.

 

[Buffalo21]

It yours, I’ll get it out

 

[Alexander McGilton]

Thank you very much for the taper adapter
Give me an address in the lower 48, yours or someone else in the community who would find use of it. Then I will send the square to whoever on your behalf.

 

[Alexander McGilton]

Im already thinking of a use for it. on occasion we do line boring on the lathe. having a taper adapter would be a better alternative to chuck.