I've got a jet 16. It uses the 1/2" studs and t-nuts.
My mill-drill also had metric feed screws which were close to 8tpi but not the same and the nut adjustment was horrible.
Had to replace all of it.
I'm machining new keys and plan to scrape the ways as the machine marks are clear in the dovetails.
My mill drill also has 14mm slots. I'm using a 5/8" kit & just milled down the T-nuts. You can find 14mm or 9/16" clamping kits but they cost more cause they're not as common.
Not sure if it matters to you but I went with 5/8" cause I wanted 1/2" studs. If you get a 1/2" kit (undersized but will work) it uses 3/8" studs.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.