Guys...thanks a ton for all the suggestions. I may give it one more try and keep in mind of the suggestions.
Ray...its 304 SS...i think its the lighting in my garage casting the tint.
I will cut a relief groove in the next on and maybe raise my bit a tad bit above center.
I am thinking toward the end of the cut, I may inadvertently travelling in a few thousands before lifting the half nut and backing the bit away causing a disruptio. Or the flow of chips following the cutter and bottoming out. I dunno...frustrating. LOL.
No biggie with the part...i can live without it. The purpose of this tool was to thread onto various barrel tenons and have indexing marks to locate where to engrave the caliber on the barrel so it lines up in the correct position. That way I dont need to screw the barrel on the action, mark the location and take it back off
Ray...its 304 SS...i think its the lighting in my garage casting the tint.
I will cut a relief groove in the next on and maybe raise my bit a tad bit above center.
I am thinking toward the end of the cut, I may inadvertently travelling in a few thousands before lifting the half nut and backing the bit away causing a disruptio. Or the flow of chips following the cutter and bottoming out. I dunno...frustrating. LOL.
No biggie with the part...i can live without it. The purpose of this tool was to thread onto various barrel tenons and have indexing marks to locate where to engrave the caliber on the barrel so it lines up in the correct position. That way I dont need to screw the barrel on the action, mark the location and take it back off