I was checking my vertical movement of my knee today. Set up a DTI so taking a reading on the fixed jaw of the vice. There was zero movement going up. On the way down however if moved. It was close to .010" but did not make an accurate check. Just wanted to check for movement.
I adjusted my gibs recently not sure if I did something wrong or not. My mill has always squawked on the downwards path. I'm wondering if the gib is to tight and holding up the knee.
Also the gib really should be replaced. IS this something I could make myself? It is the type that has two screws on either end.
I adjusted my gibs recently not sure if I did something wrong or not. My mill has always squawked on the downwards path. I'm wondering if the gib is to tight and holding up the knee.
Also the gib really should be replaced. IS this something I could make myself? It is the type that has two screws on either end.