I have some parts for my servo 150 power feed coming tomorrow. The parts are rapid switch parts, on/off, breaker toggle switch, and a cover for the nylon gear on the bottom. The movement limit switch has just been dangling on the wires since I got the mill and I would like to mount it to get the protection that it will provide. The problem is that I think there are some brackets missing. Could someone post pictures of the mounting arrangement if they have one? Also is this switch meant to stop the table in both directions (x) or just from right to left? This is the last item to fix on this mill. I fixed the quill feed yesterday. I made a new overload clutch for it.