- Joined
- Dec 21, 2018
- Messages
- 1,831
On the Kurt web site they show a "chip guard" for this vice. Mine didn't come with one. In the diagram it just looks like a very thin flat item.
What keeps it in place? Can I just make one out of sheet steel?
Also shown on the diagram are urethane O rings under the fixed jaw??? There are grooves for them on my vice. Any advice on should I get them? If they slightly raise the jaw, isn't that going to let chips under?
What keeps it in place? Can I just make one out of sheet steel?
Also shown on the diagram are urethane O rings under the fixed jaw??? There are grooves for them on my vice. Any advice on should I get them? If they slightly raise the jaw, isn't that going to let chips under?