- Joined
- Sep 29, 2010
- Messages
- 1,558
I got a 4" Lathe Dog from enco so I could clean up the over arms for my Horizontal Mill. The dog has a bent tail about 1 1/8 wide the face plate for my ATW has 5/8 slots.
Would you open the slots to 1 1/8 or cut down the tail to fit the face plate? I was thinking that if I opened up the slot I would have to do 2 that are in line so as to keep the balance right. Or would I need to do all 4 slots?
Thanks
Paul
Would you open the slots to 1 1/8 or cut down the tail to fit the face plate? I was thinking that if I opened up the slot I would have to do 2 that are in line so as to keep the balance right. Or would I need to do all 4 slots?
Thanks
Paul