- Joined
- Apr 21, 2013
- Messages
- 208
I built a simple storage rack for the BXA tooling above my Clausing 5914 lathe. I had some lightweight box metal that I tack welded some 14ga. 1 5/8" tall x 2 1/2" long pieces to. It is mounted to angle back about 5 degrees. Simple, but it sure is handy! I also added an 18" Harbor Freight tool storage magnet to the back side, which holds small wrenches, etc. Also note the magnetic tray (picked this one up a Home Depot) that is on my tailstock. A VERY hand place to keep center drills and such.
Close up of rack.
Jack
Fort Loramie, Ohio
Close up of rack.
Jack
Fort Loramie, Ohio