- Joined
- Mar 15, 2014
- Messages
- 51
I picked up a 15hp lenze 8200 vector vfd, i was thinking of using it to run my lathe(7.5hp aeg motor 220/380) on 220v single phase,
when i power it up i get a low dc bus voltage warning, live is connected to L1, neutral to L2 and i tried it with live jumpered to L3 but no joy, needless to say it won't run the motor.
Anyone got any ideas, or did i get a dud unit.
thanks,
Jim
when i power it up i get a low dc bus voltage warning, live is connected to L1, neutral to L2 and i tried it with live jumpered to L3 but no joy, needless to say it won't run the motor.
Anyone got any ideas, or did i get a dud unit.
thanks,
Jim