- Joined
- Jun 15, 2018
- Messages
- 294
In the first part of this series, lathes and turning are covered at a very general level.
Finally, a workpiece is faced and the exact outer diameter is turned.
In this video I use:
- Weiler Matador SV (1972) Lathe
The video is spoken in Finnish but it has good quality hand written subtitles in English, German and Swedish.
Finally, a workpiece is faced and the exact outer diameter is turned.
In this video I use:
- Weiler Matador SV (1972) Lathe
The video is spoken in Finnish but it has good quality hand written subtitles in English, German and Swedish.