- Joined
- Mar 23, 2023
- Messages
- 9
Would appreciate ordering info or specs for buying link belting (Fenner et al.) to replace the 2 belts on a 6" Atlas.
-Marty-
-Marty-
-
Welcome back Guest! Did you know you can mentor other members here at H-M? If not, please check out our Relaunch of Hobby Machinist Mentoring Program!
Link Belting for 6" Atlas - specs wanted
- Thread starter Marty Feldman
- Start date
- Joined
- Apr 5, 2013
- Messages
- 391
I just found this out yesterday , HF's in my area don't carry 3L link belts and that is what you need (I think) . McMaster-Carr has what you need .
As far as the length you need , only you can figure that out . It's not hard all you need is a tape measure .
Mark .
www.mcmaster.com
www.mcmaster.com
As far as the length you need , only you can figure that out . It's not hard all you need is a tape measure .
Mark .
McMaster-Carr
McMaster-Carr is the complete source for your plant with over 595,000 products. 98% of products ordered ship from stock and deliver same or next day.
McMaster-Carr
McMaster-Carr is the complete source for your plant with over 595,000 products. 98% of products ordered ship from stock and deliver same or next day.
- Joined
- Apr 23, 2018
- Messages
- 6,604
Yep, just pick the profile. My Atlas 10 used a #3 belt, but I expect the 6" Craftsman to take the next size smaller. Visit Fenner or Link-Belt's site and use their selection criteria if you don't know where to start. And the correct orientation of linked belts is, "the tails follow". It'll make sense when it is in your hands.