- Joined
- Feb 19, 2016
- Messages
- 326
I just received some goodies from LMS. Very good to deal with. As I sort thru some issues with my mill (posted on the Grizzly part of this site) I figure that I can get my vise tuned up. Yes, the mill pictured here is too short to make a full cut on the face of the part.....I used a larger mill to do the bulk of the work but, set up with a smaller dia mill to allow me to go deeper into the vee. The ramp that you see here that the hemispherical ball rides on was terrible. A big lump right where the flat of the ball rides. I have that cleaned up and would like to know what you guys are using for stoning your vises. I would prefer something that is readily available locally. Any suggestions? As for the vise.....other than being full of grinding dust, baby seal fat and general crap, it doesn't look too bad.