A while back I picked up a Dorian horizontal milling attachment setup for my BP clone. What I didn't get was an instruction manual to set it up. Does anyone have one or similar make they could copy for me?
Have you looked on Dorain's website? May have to do some digging, there should be something there. If not email them. They are pretty good people to deal with. At least that's what my brother tells me. They are close to home, too!
Thank you! I 'trammed' mine the first (and only) time I used it by running the indicating flat up to the vice. Tighten vice and the right angle head at same time and figured that since the vice is holding the work, the head will be a right angles to the work.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.