- Joined
- Mar 26, 2014
- Messages
- 1,559
A few months ago I picked up for next to nothing a large high speed steel lathe tool. They looked like they were just roughed out and whoever had them would sharpen as needed. Must have been for a large lathe, they are 1-1/2”x1-1/2” x10”. Too big for my lathe, so I set them it up in the shaper and planed 0.250 off so I could get it on centre.
Sharpened it up and even on a small round it cuts like butter.
Cheers
Martin
Sharpened it up and even on a small round it cuts like butter.
Cheers
Martin