I need a hole 2.875 in 1/2" crs near one end of part that will end up 5"x 5". I have a 2 1/2" hole saw but, that leaves me short. I have mill(PM-25MV) and lathe to work with. I have a DRO on my mill and "could" drill a lot of holes in a circle but, there must be a better way. I ruined the 1st one of these trying to use cheap rotary table that I had (returned it).
I'm guessing things like this will come up again and would appreciate any tips.
Thanks,
Regis
I'm guessing things like this will come up again and would appreciate any tips.
Thanks,
Regis