Hi All
I want to make 6mm wide by 18 teeth internal splines in c360 brass for guitar knobs.
Any ideas on how?
I'm imagining some sort of male spline bit that I punch into a hole size below the teeth diameter.
Alternatively, if I could just by plastic 18-spline inserts I'd do that but they appear to be non-existent on the Web.
I want to make 6mm wide by 18 teeth internal splines in c360 brass for guitar knobs.
Any ideas on how?
I'm imagining some sort of male spline bit that I punch into a hole size below the teeth diameter.
Alternatively, if I could just by plastic 18-spline inserts I'd do that but they appear to be non-existent on the Web.