Thank you so much @NCjeeper !!
-
Welcome back Guest! Did you know you can mentor other members here at H-M? If not, please check out our Relaunch of Hobby Machinist Mentoring Program!
Manual for an enco 12x36 510-2584
- Thread starter aGinger
- Start date
- Joined
- Jan 2, 2019
- Messages
- 6,526
Sorry to hear about your lathe getting dropped, that can cause lots of damage that's not obvious when you first look.
If you want to support this site (it's non-profit) it just requires a small $10 donation for access to all the downloads.
Well worth it in my opinion.
JOhn