- Joined
- Feb 6, 2020
- Messages
- 257
Remove the jaw faces from the inside of the vise and install on the outside of the vise.
Tram vise in new configuration.
Position part so both side edges are exposed and mill the exposed edges. This becomes reference surface #1 and #2
Position reference surface #1 on the back jaw of the vise.
Side Mill both side faces of the part. You now have 4 reference surfaces that should be very close to square.
Check that the part is approximately normal to the spindle.
Fly cut or shell mill the top of the part.
Flip part over and fly cut or shell mill the other surface.
except we clarified the parameters in post 7 - part too big for any vise (in theory)