- Joined
- May 28, 2018
- Messages
- 4
Afternoon folks.
I am finally completing my Circa 1944 Heavy 10 and with a 42 " bed I have little room to Clamp the Taper attachment and also install the bed clamp for the Tool Holder upright post.
I am thinking of drilling a 1/2" hole through the Taper Clamp and "call it a day" the taper clamp is over two inches wide so I cans see any reason it "wouldn't work.
I'm not an engineer but I think I've heard of it being done successfully .
Pertinent comments are , Of course welcome , I wouldn't chuck the drill until I read your input
As always thanks
Joe
I am finally completing my Circa 1944 Heavy 10 and with a 42 " bed I have little room to Clamp the Taper attachment and also install the bed clamp for the Tool Holder upright post.
I am thinking of drilling a 1/2" hole through the Taper Clamp and "call it a day" the taper clamp is over two inches wide so I cans see any reason it "wouldn't work.
I'm not an engineer but I think I've heard of it being done successfully .
Pertinent comments are , Of course welcome , I wouldn't chuck the drill until I read your input
As always thanks
Joe