4
4GSR
Forum Guest
Register Today
When I say "improve lubrication", I'm not talking about adding more grease or oil to the bearings or gears. I'm talking about adding pressurized oiling to the bearings and gearing, This may also include things like "oil mist" for lubrication of bearings. There are two ways to kill a bearing, (actually more ways), one is to starve a bearing of lubrication and two, over lubricate a bearing. I don't believe a 305 bearing in a VN mill is going to fail by increasing the speed by 600 RPM at the motor in MHO.
Ken
Ken