- Joined
- Apr 29, 2019
- Messages
- 2,059
My MKS Gen L V1.0 motherboard has stopped working on the E0 output. I have tried the driver in another location and it is fine, I have tried switching steppers and they are all fine. All that is left is the mother board. So now the question, is there a way to set up the motherboard to send all of the extruder commands to the currently unused E1 port. Or is that something I would have to set up in Cura telling it that I have a dual extruder and to use the other extruder??
I was looking at the MKS Robin Nano V3 from TEVOUP. Or is there a different direction I should be looking?
I was looking at the MKS Robin Nano V3 from TEVOUP. Or is there a different direction I should be looking?