- Joined
- Dec 5, 2017
- Messages
- 464
Long, long story, but my search for a 4 jaw chuck for my Seneca Falls Star 30 hasn't met with any success, so I grabbed a 4 jaw that will work if I can get an adapter made.
I can do up a dimensioned drawing if anyone is willing to take this on (for pay, of course) but the basics are as follows:
Lathe spindle is 1-9/16ths by 10TPI, with about a half-inch of threads.
These are just quick-and-dirty rough measurements: "Socket" on back of chuck is 3.92x, 4 holes on 2.94x circle.
I suspect the best approach would be to turn the major diameter slightly oversize and I'll turn it down to fit when I get it.
If someone is willing to take this on, I'll do my best to get more accurate dimensions and provide a detailed drawing.
I can do up a dimensioned drawing if anyone is willing to take this on (for pay, of course) but the basics are as follows:
Lathe spindle is 1-9/16ths by 10TPI, with about a half-inch of threads.
These are just quick-and-dirty rough measurements: "Socket" on back of chuck is 3.92x, 4 holes on 2.94x circle.
I suspect the best approach would be to turn the major diameter slightly oversize and I'll turn it down to fit when I get it.
If someone is willing to take this on, I'll do my best to get more accurate dimensions and provide a detailed drawing.