- Joined
- Jan 22, 2012
- Messages
- 655
I have been struggling with single point threading, mostly with the tooling I have. I got a cheap turning tool set that came with a 60 deg straight tool for threading that I felt never really worked very good. I bought a somewhat better (I thought) tool that had a insert that was clamped in a groove that I have tried several times but it didn't seem to clamp the insert very well causing chipping at the tip. The inserts are had to find (only found at Grizzly so far and they are back ordered). ENCO has 20% off and I found a holder that uses an insert with three cutting edges. Would this be the threading tool I have been looking for? Or other options?
Here's the link. http://www.use-enco.com/CGI/INSRIT?PARTPG=INLMKD&PMPXNO=7908977&PMAKA=422-3040
This would be used for aluminum and carbon steel with SS infrequently.
Here's the link. http://www.use-enco.com/CGI/INSRIT?PARTPG=INLMKD&PMPXNO=7908977&PMAKA=422-3040
This would be used for aluminum and carbon steel with SS infrequently.