New Bench PSU

[GreatOldOne]

A week of design in F360. Several failed prints (thankfully caught quickly). Nigh on 60 hours of printing for all 5 Parts. But I've got an awesome new Bench Power Supply to show for it.

My old supply still worked, but it was getting difficult to read... My eyes are not getting any better as I get older. These have nice large displays, a much better interface and can be controlled via wifi on my phone or laptop. They can data log as well... Not bad for the price. Definitely cheaper than a Rigol. And for my needs perfectly adequate.

Dual RD6006 / RD6012 Bench Power Supply by GreatOldOne

Dual power supply to replace my functional, but hard to read dual supply:https://www.thingiverse.com/thing:3466963 Uses the same 48v PSU as before, but this has two RD6006 programmable supplies rather than the old DPS units. You will need: 4 M3 x 25mm cap head screws 2 M3 x 16mm cap head screws...

www.thingiverse.com

 

[DAT510]

Looks great. Those are just head units, right? What did you use for your power source?

 

[GreatOldOne]

A 48v Switching DC power supply. It’s an S-500-48 which is a generic unit that several companies in China produce. I think I got it from banggood, but I can’t remember

 

[brino]

Wow!
That's really slick.

Thanks for posting!
-brino

 

[frugalguido]

Good job on that case! I just recently built a RD6006 too, but using a linear PS. One thing that I have noticed is that intermittently, the output just shuts off after a long period of time. It seems that other people have reported it too, I think is a firmware problem, but who knows.