We inherited this enco 91034.
everything works good but our issue is with the quill and/or spindle.
where the spindle holds the collets is inverted in the quill. so when using an end mill there is no room to reach anything without bumping the quill. how do we get the spindle to protrude from the bottom like you normally see.
everything works good but our issue is with the quill and/or spindle.
where the spindle holds the collets is inverted in the quill. so when using an end mill there is no room to reach anything without bumping the quill. how do we get the spindle to protrude from the bottom like you normally see.