- Joined
- Feb 2, 2014
- Messages
- 1,080
After seeing Joe_B's , Ipeedin's and several others posts I thought I would try my hand at it too.
This mill is from the early 90s so the grub screws were 8mm X 1.25 and screwed in over an inch before touching the gib so I just reused them.
Pull out to lock and tap in to release.
Moves freely without much effort to lock or unlock.
Thanks for looking
Ray
This mill is from the early 90s so the grub screws were 8mm X 1.25 and screwed in over an inch before touching the gib so I just reused them.
Pull out to lock and tap in to release.
Moves freely without much effort to lock or unlock.
Thanks for looking
Ray