I have the OXA toolpost on my mini lathe.
When I tighten the post to secure the toolholder, all is good.
The lever has a tendency to "open" during use -- the toolholder remains completely secure, but the handle will move around.
Only when opened further will the tool release.
I have tried to find an adjustment, e.g. removing the wedges and reseating them, but can not eliminate this problem.
Is this normal, or is there an adjustment that I haven't identified?
Thanks.
When I tighten the post to secure the toolholder, all is good.
The lever has a tendency to "open" during use -- the toolholder remains completely secure, but the handle will move around.
Only when opened further will the tool release.
I have tried to find an adjustment, e.g. removing the wedges and reseating them, but can not eliminate this problem.
Is this normal, or is there an adjustment that I haven't identified?
Thanks.