I have an X2, cncfusion kit ballscrew kit, mach3, g540 controller, 48Volt Nema23 motors. Backlash adjusted and properly setup Steps per. The machine is 2.4ghz, with has been tested with the driver check and passed.
Created this is meshcam with roughing, xy finish, AND a pencil clean up.
But something happens in the Y axis. Check the pictures and see how the pencil pass cleans up the front of the oval but has drifted past the rear oval shape and leaves the rough edges, literally pencil passing in the air far past. I looks like it has come over a millimeter off?
The motors sound fine i think.
Why is this happening? Am i missing something here? Too tight gib screws? Missing steps?
This is what it sounds and looks like:
http://www.youtube.com/watch?v=lx5FjR5Lk7I
Front side is finished with pencil cleanup:
Back side is not because the pencil path has drifted too far from the surface:
Sent from my iPhone using Tapatalk - now Free
Created this is meshcam with roughing, xy finish, AND a pencil clean up.
But something happens in the Y axis. Check the pictures and see how the pencil pass cleans up the front of the oval but has drifted past the rear oval shape and leaves the rough edges, literally pencil passing in the air far past. I looks like it has come over a millimeter off?
The motors sound fine i think.
Why is this happening? Am i missing something here? Too tight gib screws? Missing steps?
This is what it sounds and looks like:
http://www.youtube.com/watch?v=lx5FjR5Lk7I
Front side is finished with pencil cleanup:
Back side is not because the pencil path has drifted too far from the surface:
Sent from my iPhone using Tapatalk - now Free