[4]

PM-932M Mill Base Measurements

[3]
[10] Like what you see?
Click here to donate to this forum and upgrade your account!

laverdamike

Newbie
Registered
Joined
Jan 26, 2015
Messages
3
Likes
2
#1
After many months of mulling it over, I finally sprung for my first mill ... a PM-932M. It's scheduled to arrive sometime in the next several weeks, and I am itching to get started on making a stand for it. According to the manual on the PM website, the hole spacing for the base is 12.75" x 18.75". I assume the base exterior dimensions are about 15" x 21" (just a guess). If anyone could post the base length/width measurements, I would greatly appreciate it. BTW...the mill will be in good company with my Sheldon 9-inch lathe, which I believe was made sometime in the late 1940s.
Cheers,
Mike
 
U

umahunter

Guest - Please Register!
Guest - Please Register!
#2
If you search my post I just had a similar post awhile back when I got my mill there's pics of a couple different people's stand on there as well as a post with the stand I built
 

laverdamike

Newbie
Registered
Joined
Jan 26, 2015
Messages
3
Likes
2
#3
Thanks, Umahunter. I checked out your post and got some good ideas for a stand. I am still waiting for my mill to arrive; it should be here sort of soon. I'll post some photos of my stand when it's done.
Mike
 

rherrell

H-M Supporter - Gold Member
H-M Supporter - Gold Member ($25)
Joined
Mar 25, 2015
Messages
91
Likes
132
#4
The very bottom is 15.75" X 24", it tapers down at the top where the bolts go through.
 
[6]
[5] [7]
Top