I had some time to work on it today and got a bit accomplished.
Drilled and tapped the mounting holes and leveled it on the lathe.
I had to use a copper shim under the stop because it wouldn't tighten down on the ways. I'll take a light cut off of it on the mill and fix that sometime.
I'll try it out tomorrow and see how it does.
Excuse my mess, I haven't cleaned up after drilling and tapping yet.
Drilled and tapped the mounting holes and leveled it on the lathe.
I had to use a copper shim under the stop because it wouldn't tighten down on the ways. I'll take a light cut off of it on the mill and fix that sometime.
I'll try it out tomorrow and see how it does.
Excuse my mess, I haven't cleaned up after drilling and tapping yet.
